Installation Location - Sanyo VW-VF10BG Technical Data & Service Manual

2. Installation Location

1. Install in a location where air circulates easily. Make sure
that there are no objects obstructing the flow of air at the
intake and outlet.
2. Be sure to ensure the space around the unit as shown in
the figure at right. Allow a servicing space of 100 cm or
more to the front of the unit.
CAUTION
3. Use the provided chain in order to prevent the unit from
tipping over due to an earthquake or other event. Failure
to do so may result in an accident if the unit tips over.
4. Do not install in a location that is unstable or not level.
(Install at an inclination of 2° or less between the two
sides.) Installation in an unstable or inclined location
may result in greater operating noise and the risk of tipping over. If the unit tips over, water will spill out.
5. Be sure to connect the ground wire.
CAUTION
G
Nearby windows and other locations that are susceptible to the effects of outside air, locations where
water freezes easily, or locations that receive direct air from an air conditioner or similar device
G
Locations exposed to direct sunlight or locations near heaters
In these locations, the unit may become deformed or discolored. In addition, because the temperature is
higher, the water inside the system may become unsanitary.
G
Nearby curtains, or on carpets
These objects can obstruct the intake and outlet, and can cause system malfunction. Dust sucked into the
intake may also cause system malfunction.
G
High locations, inclined locations, or unstable locations
Earthquakes or human contact may cause the unit to fall or tip over. If the unit is installed in an inclined
location, the water level sensor may be activated, causing the ADD WATER lamp to turn ON and stopping
operation.
Chain fastening location
Outlet (Automatic louver)
7
Control section panel
39 200
297
Avoid installing in locations such as those listed below.
Installation Dimensions and Part Names
Display
Front
upper panel
Electrical
component
box
Front
lower panel
60 230
Minimum
10 cm
1ø AC 220 – 240 V
2-pin plug
with grounding socket
Chain fastening location
Water tank panel
Water tank
Handle
Intake filter
Drainage
tank
230 60
580
7 - 3
Installation
Minimum 100 cm
Minimum
10 cm
Minimum 100 cm
Virus Washer element
Chain
fastening
location
200 39
297
Unit: mm