Filling The Water Tank; When The Water Tank Runs Dry (When The Add Water Lamp Lights) - Sanyo VW-VF10BG Technical Data & Service Manual

2. Filling the water tank

The water supply is necessary in order to generate
electrolyzed water.
CAUTION
G
Fill the water tank with new tap water every day, and
keep the tank clean at all times.
If water is left in the tank, mold or bacteria may grow in it,
resulting in odor.
Be careful that dirt and foreign matter do not enter the
*
tank installation port.

3. When the water tank runs dry (when the ADD WATER lamp lights)

When the water tank is empty, operation stops automatically, the ADD WATER lamp lights, and the buzzer sounds
to notify the user.
Fill the water tank with tap water, and insert it into the system, then press the ON/OFF button twice
to start operation.
Pressing this button the first time turns the OPERATION lamp and ADD WATER lamp OFF. Pressing it a second
time starts operation. Approximately 3 minutes of preparation are required before the system begins operating.
While this preparation is in progress, the fan remains stopped and no air is discharged from the system.
Be sure to use normal tap water.
G
Never use water from a water purifier, water from a water heater, alkali ion water, mineral water, well water,
seawater, or other similar types of water. These types of water cannot be electrolyzed and can result in odor
due to mold or bacteria.
G Never use hot (40°C or higher) water, water that contains chemicals, hazy or dirty water, or water that contains
aromatics or detergents. These types of water cannot be used to purify the air, and may cause deformation or
malfunction of the system.
G Be sure to tighten the cap securely and check that there is no water leakage.
G
Place the full tank into the system gently in order to avoid damaging the water tank panel and the electrolyzed
water tray.
The electrolysis condition setting must be set correctly according to the water quality
in the region where the product is used. For details, refer to "Setting the electrolysis
condition."
G
Salt must be used in some regions. For details, refer to "Adding salt."
When the ADD WATER lamp lights, it is not possible to create electrolyzed water.
Therefore refill the water tank with tap water right away.
G
You may also refill the water tank before the ADD WATER lamp lights.
Important Information
2 - 4
Using this System
2
Fully tighten the cap.
1
Fill with water
to this point.
The water tank holds approximately
6 liters of water.
Change the water every day.
2