Advertisement
• The TV can be controlled from a PC, control panels and other devices using the RS-232C or IP.
• Use a cross-type
RS-232C cable, ETHERNET
cable (commercially
available) or wireless
LAN for
the connections.
• This operation system should be used by a person who is accustomed to using computers.
Set this function when operating the TV from equipment connected
by LAN or wireless
LAN. To
perform the operation,
refer to "Smart TV".
Remote
Control
App
When "Remote Control App" is selected, "Change" will be highlighted.
Press ENTER.
Detailed
Settings
Make the detailed settings (Login ID, password,
etc.).
Follow the on-screen
instructions
to configure
the settings.
Set the name of the TV displayed on other network devices.
• Use the software keyboard
to set the name.
See Daae 9-5 for details on the software keyboard.
Connect to the TV with the following settings
made for IP on the PC.
IP protocol:
TCP/IP
Host IP address:
Set the IP address on the TV menu
Service:
None (Do net select Telnet or SSH)
TCP port#:
Set a port number on the TV menu (Control
port)
When you set your ID and password
on the TV menu, you need to enter them as soon as you
connect to the TV.
• When you use this function, make settings for "AQUOS Remote Control".
• The connection will be cut off when there has been no communication
for 3 minutes.
Baud rate:
Data length:
Parity bit:
Stop bit:
Flow control:
Communication
procedure
Set the RS-232C communication
settings on the PC to match the TV's communication
conditions.
The TV's communication
settings are as follows:
9,600 bps
8 bits
None
1 bit
None
Send the control commands
from the PC via the RS-232C or IP.
The TV operates according to the received command and sends a response
message to the PC.
Do not send multiple commands at the same time.
Wait until the PC receives the OK response
before sending the next command.
ENG 8-3
Advertisement
