Table of Contents
Advertisement
1
1-13 Connecting network cable to the ColorPASS
Ethernet connection
For Ethernet connections, the ColorPASS supports Unshielded Twisted Pair (UTP,
4 pairs) cabling, defined as Category 5 or later for use with 100BaseT and 1000BaseT;
or as Category 3, Category 4, or Category 5 for use with 10BaseT. The cable uses an
8-pin RJ-45 connector that plugs into the RJ-45 socket on the ColorPASS.
The 100BaseT and 1000BaseT types supported by the ColorPASS are
N
:
OTE
100BaseTX and 1000BaseTX, respectively, also known as Fast Ethernet. If an Ethernet
hub is used, it must be a 100BaseTX or 1000BaseTX hub. The term "100BaseT" and
"1000BaseT" are used to refer to 100BaseTX and 1000BaseTX, respectively.
T
E
O CONNECT TO THE
THERNET BOARD
•
Connect the network cable to the RJ-45 connector on the back of the ColorPASS.
You must use a Category 5 or later unshielded twisted pair network cable for
100BaseT and 1000BaseT.
Advertisement
Table of Contents
