Table of Contents
Advertisement
15 KDS-100
1 Connect one end of the KCT-39 to the transceiver. Refer to Section "11 KCT-39" for installation.
2 Connect the opposite end of the KCT-39 to the KDS-100.
3 Program the Function Port using KPG-80D, to activate the KDS-100.
4 Select "Edit > Function Port" in the Menu.
5 Select KDS-100 for the External Devices to assign functions to each port for operating the KDS-100.
6 Select "Program > Write to Radio" in the FPU Menu.
7 The configuration data is sent to the transceiver.
8 The KDS-100 automatically activates when the transceiver is turned ON.
Note: You must use KPG-71D to program the KDS-100.
Note: Select "Edit > Optional Features > Radio" in the FPU Menu to program the logic of each port.
SQ
DTC
TXS/LOK
AM
MM
55
Squelch detect input
Data TX channel Control output
Transmitter active sense input
Speaker mute output
MIC mute output
Select KDS-100
All necessary parameters for the
KDS-100 are automatically
configured.
Active Low
Active Low
Active Low
Active Low
Active Low
Advertisement
Table of Contents
