Right Side - JVC 0210TTH-SW-VP Instructions Manual

Right Side

I
[DVI 1 to 4] Terminal
This is an input terminal for video signals. Connect it to
the video output terminal of the computer.
(A Page 21, 23)
J
[USB] Terminal
Enables control of this projector by connecting it to a
computer.
K
[LAN] Terminal
Enables control of this projector using a computer that is
connected to the network.
L
[RS-232C] Terminal
This is the RS-232C interface-specific terminal. This
projector can be controlled by connecting it to a computer
using a RS-232C cable.
M
[OPERATE I/B] Button
Pressing this button for one second or longer when in the
standby mode (main power supply is ON) turns on the
power of the projector unit. Pressing it for one second or
longer when the power is ON switches the projector to
the standby mode.
N
[WARNING] Indicator
This indicator lights up in red when abnormality occurs on
this projector. For details, refer to Warnings Using
Indicators . (A Page 54)
I
DVI 1
DVI 2
CONTROL
USB
DVI 3
LAN
STANDBY/ON
OPERATE I/B
LAMP
DVI 4
WARNING
RS-232C
J K L M N O P Q
O
[LAMP] Indicator
This indicator lights up in yellow when the lamp time
exceeds 1900 hours.
NOTE:
● For details on indicator displays during warnings, refer
to Warnings Using Indicators . (A Page 54)
● A lamp life message appears when the lamp time has
exceeded 2000 hours.
(A Page 53)
P
AC Power Input Terminal
Connect the supplied cord to this terminal.
Q
Main Power Supply Switch
Use this to turn ON/OFF the main power supply of the
projector unit.
R
[STANDBY/ON] Indicator
Lit (Red) : When in the standby mode.
Lit (Green) : When power is supplied.
Blinking (Red) : When cooling down (cool down mode).
(A Page 31)
Blinking (Green) : When the projected image is
temporarily hidden. (A Page 31)
NOTE:
● For details on indicator displays during warnings, refer
to Warnings Using Indicators . (A Page 54)
R