Table of Contents
Advertisement
Projector Installation Angle
You can install this projector between
Images will be properly displayed if the horizontal angle
is between the range of
5 .
However, you have to configure using [Installation
Style](A Page 48) for certain installation orientations.
A: Upward installation
B: Horizontal installation (-45 to +45 )
C: Downward installation (-45 to -90 )
A: +45 to +90
+45
B: -45 to +45
DVI 1
DVI 2
CONTROL
USB
DVI 3
LAN
OPERATE I/B
STANDBY/ON
LAMP
DVI 4
WARNING
RS-232C
-45
C: -45 to -90
5
CAUTION:
● To ceiling-mount this unit, special expertise and skills
are necessary. Make to sure request the authorized
dealer or specialized work contractors for installation.
● The projector cannot be installed upside down.
Adjusting the Inclination
Adjust the horizontal angle of the projector.
Lift the projector and turn the nut of the adjustable foot
with a spanner in the direction indicated by the arrow to
extend or retract the foot. The adjustable range is 20 mm.
Extend
Retract
90 .
(+45 to +90 )
+90
T Not applicable
-90
5
Installing the Projector
and Screen
It is recommended that this projector be installed at right
angle to the screen.
When a zoom lens (optional) is in use, you can make use
of the lens shift feature of this projector to shift the
projection screen vertically between 0% to
horizontally between 0% to
When a short focal length lens (optional) is in use, you
can shift the projection screen position vertically between
0% to
15%, and horizontally between 0% to
Below are some examples on the layout when a zoom
lens is used.
When shift amount in the upward direction is
+50 %
Install the projector such that the lower end of the
projection screen is at the same height as the center of
the lens.
Screen
90
90
90
Center Line of Lens
When shift amount in the upward/downward
direction is 0 %
Install the projector such that the center of the projection
screen is at the same height as the center of the lens.
Screen
90
90
90
Center Line of Lens
When shift amount in the downward direction
is -50 %
Install the projector such that the upper end of the
projection screen is at the same height as the center of
the lens.
Center Line of Lens
Screen
90
90
50%, and
25%.
5%.
90
Advertisement
Table of Contents
