Table of Contents
Advertisement
Getting Started
Names and Functions of
Parts
Front/Right/Rear Side
A
Intake air
B
C D
A
Air Inlet/Filter
The air inlets absorb air to cool the interior of the
projector. A filter is mounted inside the projector to
remove dirt in the air that enters through the inlets. Clean
the filter regularly. (A Page 58)
CAUTION:
● Do not block the air inlets with papers, cloth, or soft
cushions. Doing so may cause heat to trap inside the
projector and result in fire or malfunction.
B
Lens Cap (included with the optional lens)
Fit the cap on the lens when this projector is not in use to
prevent the lens from becoming dirty.
CAUTION:
● Do not project images with the lens cap attached. The
lens cap may be deformed due to the heat, or the
projector may malfunction.
C
Projection Lens (optional)
Zoom lens or short focal length lens is optional.
(A Page 60)
Remove the lens cap before projection.
F
E
F
Intake
air
NT RO
L
CO
Intake
air
F
D
Lens Mounting Bracket
Mount the optional projection lens.
E
Adjustable Feet (x4)
Adjust the feet until the projector is level. The adjustable
range is 20 mm for each. (A Page 15)
F
Air Inlet/Filter (Right Side: x3, Left Side: x1)
The air inlets absorb air to cool the interior of the
projector. A filter is mounted inside the projector to
remove dirt in the air that enters through the inlets. Clean
the filter regularly. (A Page 58)
G
Vent Hole
Warm air exits from the hole after cooling the projector.
CAUTION:
● Do not block the vent holes with papers, cloth, or soft
cushions. Doing so may cause heat to trap inside the
projector and result in fire or malfunction.
H
Vent Hole
Warm air exits from the hole after cooling the lamp.
G
H
Exhaust air
Exhaust air
Advertisement
Table of Contents
