Ip Address Settings; Assigning A Static Ip Address - JVC 0210TTH-SW-VP Instructions Manual

Network Settings

IP Address Settings

Set the IP address for this projector. There are 2 methods to set the IP address.

Assigning a static IP address

Assigning an IP address from the DHCP Server
Assigning a static IP address
The IP Address Setting of this projector is set to STATIC IP (the DHCP client function is OFF) by default.
Upon turning on the power, this projector starts running with the following IP address.
IP Address : 192.168.0.2
Subnet Mask : 255.255.255.0
Default Gateway : 192.168.0.254
IP address setting at the computer
Set the computer to an IP address that enables communication with this projector.
1
Click Start and select Control Panel
2
Double click Network Connections
3
Right-click on Local Area and select Properties
● Check to ensure that the Client for Microsoft Networks and Internet Protocol(TCP/IP) check boxes are selected.
4
Select Internet Protocol(TCP/IP) and click Properties
5
Set the IP address
6
Click OK on the Local Area Connection Properties screen
Select Use the following IP address
A
B Set IP address
(For example, use 192.168.0.100 when DLA-SH7NL is in its
default settings)
NOTE:
● Make sure that you take note of the original IP address
before altering.
● When setting, ensure that a duplicate IP address is not
used within the same network environment.
Set Subnet mask
C
Set to a value that is appropriate for the setting operation.
Clarify with the network administrator if you have any queries.
(Use 255.255.255.0 when the camera is in its default settings)
When a Default gateway is present, make use of the IP
D
address (e.g., 192.168.0.254)
Click OK
E