Dell 2135cn Service Manual page 573

Hide thumbs Also See for 2135cn:

Table of Contents

Chapter 3 Removal and Replacement Procedures (RRPs)

Removal 36 KIT FEED ROLL/SOL/CLUTCH (PL10.4.99)

1) Remove the Tray 1. (Removal 1)

2) Open the COVER ASSY FRONT (PL10.2.1).

Note: Cover the drum of the PHD unit to avoid exposure to light.

3) Remove the PHD Unit. (Removal 3)

Note: The FUSER part is very hot. Take added care not to get burned when performing the

service operation.

4) Remove the FUSER ASSY. (Removal 9)

5) Remove the COVER ASSY SIDE R. (Removal 10)

6) Remove the COVER ASSY SIDE L. (Removal 14)

7) Remove the COVER POLE OUT. (Removal 15)

8) Remove the COVER REAR. (Removal 17)

9) Remove the COVER TOP. (Removal 18)

10) Remove the COVER SIDE L LOW. (Removal 20)

11) Remove the CHASSIS ASSY LVPS. (Removal 28)

12) Remove the KIT DRIVE ASSY PH. (Removal 32)

13) Release the hook of the ROLL CORE

MSI (PL3.2.3) on the left of the ROLL

ASSY FEED (PL 3.2.4), and move the

ROLL CORE MSI to left until it stops.

Chapters

Table of Contents