Fip-1. 23 Memory Full 016-700 - Dell 2135cn Service Manual

FIP-1. 23 Memory Full 016-700

Step
Possible causative parts:
PWBA CONT AIO (PL10.6.6)
Checking optional memory.
1
Is the optional memory module installed?
Checking after changing the printer driver settings.
In the printer driver dialog box, set Print Mode to "High
2
Quality", and Bitmap Smoothing to "On".
Does the error still occur when printing?
Checking after installing the optional memory.
3 Install additional memory.
Does the error still occur when printing?
Print a System Settings page to verify the capacity of
optional memory. (Refer to NOTE)
Is memory capacity increased?
4 NOTE: Operation from printer operation panel
1 Press until >SETUP appears, and then press .
2 Press until >Reports appears, and then press .
3 System Settings is displayed. Press .
Print a System Settings page to verify the capacity of
optional memory. (Refer to NOTE)
Is memory capacity increased?
5 NOTE: Operation from printer operation panel
1 Press until >SETUP appears, and then press .
2 Press until >Reports appears, and then press .
3 System Settings is displayed. Press .
Checking after changing the printer driver settings.
In the printer driver dialog box, set Print Mode to "High
6
Quality", and Bitmap Smoothing to "On".
Does the error still occur when printing?
Checking after changing the RAM DISK settings.
Set RAM DISK to "100MB". (Refer to NOTE)
Does the error still occur when printing?
NOTE: Operation from printer operation panel
7 1 Press until >SETUP appears, and then press .
2 Press until >Admin Menu appears, and then press .
3 Press until >System Settings appears, and then press
.
4 Press until >RAM Disk appears, and then press .
Version 4.3 2009.10.09
Check
1 - 251
Chapter 1 Troubleshooting
Remedy
Yes
Go to step 5. Go to step 2.
Go to step 3. End of work.
Go to step 4. End of work.
If the memory
capacity has not
increased, turn off
Go to step 6. the printer, unplug
the power cable,
and reinstall the
optional memory.
If the memory
capacity has not
increased, turn off
Go to step 6. the printer, unplug
the power cable,
and reinstall the
optional memory.
Go to step 7. End of work.
The printer has
reached its
processing
capacity. Try
dividing the print
End of work.
data into smaller
blocks or
converting the
data to a smaller
format.
No