Parameter - Dell 2135cn Service Manual

4.1.4 Parameter

- Continue Illegal
Specifies how to handle the document data when the document data in the transmission queue
overflows the memory.
Clear
Transmit
- Thresh Memory RX (%)
Sets the amount of memory to be left free when the received document data is stored. When the
remaining memory amount falls below this threshold, data reception is denied.
The value can be set in the range of 0 to 100. The smaller the value, the larger the memory capac-
ity becomes
- Thresh Immediate (%)
Sets the remaining memory amount threshold that triggers immediate output. Immediate output
refers to an automatic image data output that is performed to accommodate the overflowing data
when the incoming document data exceeds the memory capacity.
The value can be set in the range of 0 to 99. The larger the value, the sooner the immediate output
is initiated.
- Thresh Memory TX (%)
Sets the amount of memory to be left free when the document data is placed in the transmission
queue.
The value can be set in the range of 0 to 100. The smaller the value, the larger the memory capac-
ity for transmission queue becomes.
- Thresh GC (%)
Sets the remaining memory amount in the Flash file system for image data storage that triggers
the "garbage collection"
- Page Margin 1 (mm): Valid when the Discard Size setting in Fax Setting is "OFF".
Sets the page size margin that allows a larger-than-standard size document to be handled as a
standard size document. The document is reduced to the standard size, assuming it is larger than
the standards size by the set value.
The value can be set in the range of 0 to 127. When the value is 10, the margin is 10 mm.
- Page Margin 2 (mm): Valid when the Discard Size setting in Fax Setting is "ON".
Sets the page size margin that allows a larger-than-standard size document to be handled as a
standard size document. The document is reduced to the standard size, assuming it is larger than
the standards size by the set value.
The value can be set in the range of 0 to 127. When the value is 10, the margin is 10 mm.
Version 1 2008.02.01
Delete the document data.
Place the portion of the document data up to
the memory limit in the transmission queue.
2 - 10
Chapter 2 Operation of Diag.