Yamaha MT-01 T 2005 Service Manual page 68

1. Air temperature sensor coupler
2. Sub-wire harness 3 coupler
3. Front turn signal light coupler
4. Headlight assembly coupler
5. Headlight coupler (low beam)
6. Wire harness
7. Clutch fluid reservoir hose
8. Left handlebar switch lead
9. Starter motor lead
10. Rectifier/regulator
11. Stator coil assembly lead
12. Horn
13. Horn lead
14. Front brake hose
15. Throttle cable (accelerator cable)
16. Throttle cable (decelerator cable)
17. Front brake fluid reservoir hose
A. Fasten the air temperature sensor lead and sub-
wire harness 3 with the harness holder.
B. Pass the brake hose through the guide on the
meter assembly bracket, making sure to fit the
grommet on the hose in the guide.
C. Make sure that the brake hose three-way joint
contacts the tab on the front brake hose joint
bracket.
D. Fasten the wire harness, stator coil assembly lead,
rectifier regulator lead, and horn lead with the
holder. Face the fastener of the holder forward.
E. Fasten the horn leads with the holder. Face the
open ends of the holder upward.
F. There should be no slack in the horn leads
between the holder and the guide on the horn
bracket.
G. Pass the horn lead through the guide on the horn
bracket.
H. Pass the wire harness through the guide.
I. Route the right handlebar switch lead behind the
throttle cables.
J. Route the right handlebar switch lead and front
brake light switch lead over and in front of the front
brake hose.
2-42
CABLE ROUTING