Bleeding The Hydraulic Brake System - Yamaha MT-01 T 2005 Service Manual

M MMM M MMM M M MMM M
a. Hold the main body "1" of the rear brake light
switch so that it does not rotate and turn the
adjusting nut "2" in direction "a" or "b" until the
rear brake light comes on at the proper time.
Direction "a"
Brake light comes on sooner.
Direction "b"
Brake light comes on later.
1
2
a
b
L LLL L LLL L L LLL L
EAS21360
BLEEDING THE HYDRAULIC BRAKE
SYSTEM
EWA13100
WARNING
Bleed the hydraulic brake system whenever:
• the system is disassembled.
• a brake hose is loosened, disconnected or
replaced.
• the brake fluid level is very low.
• brake operation is faulty.
NOTE:
• Be careful not to spill any brake fluid or allow
the brake fluid reservoir to overflow.
• When bleeding the hydraulic brake system,
make sure there is always enough brake fluid
before applying the brake. Ignoring this pre-
caution could allow air to enter the hydraulic
brake system, considerably lengthening the
bleeding procedure.
• If bleeding is difficult, it may be necessary to let
the brake fluid settle for a few hours. Repeat
the bleeding procedure when the tiny bubbles
in the hose have disappeared.
1. Bleed:
• Hydraulic brake system
M MMM M M MMM M M MMM M
L LLL L L LLL L L LLL L
MMM M MMM M MMM M
a. Fill the brake fluid reservoir to the proper level
with the recommended brake fluid.
b. Install the brake fluid reservoir diaphragm.
c. Connect a clear plastic hose "1" tightly to the
bleed screw "2".
1
A
1
2
LLL
C
A. Front brake master cylinder
B. Front brake caliper
C. Rear brake caliper
NOTE:
The bleeding order of the front hydraulic brake
system is the following:
1. Front brake master cylinder
2. Front brake calipers
3. Front brake master cylinder
d. Place the other end of the hose into a con-
tainer.
e. Slowly apply the brake several times.
f. Fully pull the brake lever or fully press down
the brake pedal and hold it in position.
g. Loosen the bleed screw.
3-23
CHASSIS
M MMM M M MMM M M MMM M
2
M MMM M MMM
1