Assembling The Front Wheel; Adjusting The Front Wheel Static Balance - Yamaha MT-01 T 2005 Service Manual

• Oil seals
Damage/wear → Replace.
EAS21960

ASSEMBLING THE FRONT WHEEL

1. Install:
• Wheel bearings New
• Oil seals
New
M MMM M MMM M M MMM M
a. Install the new wheel bearings and oil seals in
the reverse order of disassembly.
EC5YU1001
CAUTION:
Do not contact the wheel bearing inner race
"1" or balls "2". Contact should be made
only with the outer race "3".
NOTE:
Use a socket "4" that matches the diameter of
the wheel bearing outer race and oil seal.
L LLL L LLL L L LLL L
EAS21970
ADJUSTING THE FRONT WHEEL STATIC
BALANCE
NOTE:
• After replacing the tire, wheel or both, the front
wheel static balance should be adjusted.
• Adjust the front wheel static balance with the
brake disc installed.
1. Remove:
• Balancing weight(s)
2. Find:
• Front wheel's heavy spot
M MMM M M MMM M M MMM M
L LLL L L LLL L L LLL L
NOTE:
Place the front wheel on a suitable balancing
stand.
M MMM M MMM M
a. Spin the front wheel.
b. When the front wheel stops, put an "X
at the bottom of the wheel.
MMM
c. Turn the front wheel 90° so that the "X
is positioned as shown.
d. Release the front wheel.
e. When the wheel stops, put an "X
the bottom of the wheel.
f. Repeat steps (d) through (f) several times un-
til all the marks come to rest at the same spot.
g. The spot where all the marks come to rest is
the front wheel's heavy spot "X".
L LLL L LLL L
3. Adjust:
• Front wheel static balance
LLL
M MMM M MMM M
a. Install a balancing weight "1" onto the rim ex-
actly opposite the heavy spot "X".
NOTE:
Start with the lightest weight.
4-9
FRONT WHEEL
M MMM M M MMM M M MMM M
L LLL L L LLL L L LLL L
M MMM M M MMM M M MMM M
M MMM M MMM
" mark
1
" mark
1
" mark at
2
L LLL L LLL
M MMM M MMM