Adjusting The Exup Cables - Yamaha MT-01 T 2005 Service Manual

4. Install:
• Seat
Refer to "GENERAL CHASSIS" on page 4-1.
EAS21100

ADJUSTING THE EXUP CABLES

1. Remove:
• EXUP valve pulley cover "1"
2. Check:
• EXUP system operation
M MMM M MMM M M MMM M
a. Turn the main switch to "ON".
b. Check that the EXUP valve operates proper-
ly.
NOTE:
Check that the projections "a" on the EXUP
valve pulley contact the stopper "b" (fully-open
position) and the stopper "c" (fully-closed posi-
tion).
a
b
L LLL L LLL L L LLL L
3. Check:
• EXUP cable free play (at the EXUP valve pul-
ley) "a"
14
15
1
M MMM M M MMM M M MMM M
c
L LLL L L LLL L L LLL L
4. Adjust:
• EXUP cable free play
M MMM M MMM M
a. Slide back the rubber cover.
b. Loosen both locknuts "1".
MMM
c. Insert a 3.5 mm (0.14 in) pin "2" through the
projections "a" in the EXUP valve pulley and
into the hole "b" in the EXUP valve cover.
2
d. Turn both adjusting nuts "3" in or out until the
specification.
Turn in "c" →
Free play is increased.
Turn out "d" →
Free play is decreased.
LLL
3-18
EXUP cable free play (at the
EXUP valve pulley)
a: 3 mm (0.12 in) or less
b: 0 mm
a
b
a
b
M MMM M M MMM M M MMM M
1
1
a
b
ENGINE
M MMM M MMM