Toro ProCore Processor Service Manual page 99

7. Adjust drive belt idler pulleys to achieve proper ten-
sion on drive belts (see Operator's Manual). After ad-
justment, make sure that chopper axle and brush shaft
are still properly aligned (Fig. 23).
IMPORTANT: After adjusting belt tension, check
that distance from idler pulley face to the faces of
the drive and driven pulleys is correct (Figs. 24 and
25). This distance is necessary to ensure that idler
pulley is correctly aligned to drive belts. If neces-
sary, re- -adjust positions of drive and driven pulleys
to allow correct distance.
8. Install belt covers (see Drive Belt Covers in this sec-
tion).
9. Install rear cover to machine (see Rear Cover Instal-
lation in this section).
ProCore Processor
1
Idler Face to Sheave Face
1. Jack shaft
2. Chopper axle
1
UP
1. Brush shaft
2. Chopper axle
Page 6 - - 23
FRONT
3
2
0.250" (6.3 mm)
Figure 24
3. Idler pulley
3
0.050" (1.3 mm)
Idler Face to Sheave Face
Figure 25
3. Idler pulley
2
Chassis