Toro ProCore Processor Service Manual page 113

Removal (Fig. 38)
1. Park ProCore Processor on a level surface with the
Processor fully lowered. Make sure that Processor en-
gine is off. Remove key from the ignition switch. Chock
wheels to prevent movement of machine.
2. On both sides of machine, remove two (2) cap
screws and flange nuts that secure pivot (item 9) to ma-
chine frame. Slide pivot from rear cover subframe pivot.
3. On both sides of machine, remove two (2) cap
screws, flat washers and flange nuts that secure rear
cover subframe hoop (item 2) to machine frame.
4. Remove two (2) carriage screws and flange nuts that
secure rear cover pivot components (items 10 and 14)
to chopper housing.
5. Lift rear cover assembly from machine.
6. Disassemble rear cover assembly as necessary us-
ing Figure 38 as a guide.
Installation (Fig. 38)
1. Assemble rear cover using Figure 38 as a guide.
2. Position rear cover assembly to machine.
3. Secure rear cover to machine:
A. Secure rear cover pivot components (items 10
and 14) to chopper housing with two (2) carriage
screws and flange nuts (Fig. 41).
NOTE: The pivot (item 9) includes a flange bushing.
Make sure that when pivot is installed to machine,
the bushing flange is orientated toward center of ma-
chine (Fig. 42).
B. On both sides of machine, slide pivot (item 9) onto
rear cover subframe pivot and secure pivot to frame
with two (2) cap screws and flange nuts.
C. On both sides of machine, secure rear cover sub-
frame hoop (item 2) to machine frame with two (2)
cap screws, flat washers and flange nuts.
ProCore Processor
2
6
4
1. Subframe pivot
2. Backing plate hook
3. Flange nut
3
1. Pivot (RH shown)
2. Bushing flange
3. Subframe pivot
Page 6 - - 37
4
5
Figure 41
4. Pivot
5. Chopper housing
6. Carriage screw
2
1
6
5
Figure 42
4. Cap screw (2 used)
5. Endplate
6. Flange nut
1
2
3
4
Chassis