Electrical System Quick Checks; Battery Test (Open Circuit Test); Charging System Test - Toro ProCore Processor Service Manual

Electrical System Quick Checks

Battery Test (Open Circuit Test)

Use a digital multimeter to measure the battery voltage.
Set the multimeter to the DC volts setting. The battery
should be at a temperature of 60
C). The ignition switch should be in the OFF position and
all accessories turned off. Connect the positive (+) multi-
meter lead to the positive battery post and the negative
(--) multimeter lead to the negative battery post. Record
the battery voltage.
NOTE: This test provides a relative condition of the bat-
tery. Load testing of the battery will provide additional
and more accurate information (see Battery Service in
the Service and Repairs section).

Charging System Test

This is a simple test used to determine if a charging sys-
tem is functioning. It will tell you if the charging system
has an output, but not its capacity.
Use a digital multimeter set to DC volts. Connect the
positive (+) multimeter lead to the positive battery post
and the negative (--) multimeter lead to the negative bat-
tery post. Keep the test leads connected to the battery
posts and record the battery voltage.
NOTE: When cranking the engine, the battery voltage
will drop and then should increase once the engine is
running.
NOTE: Depending upon the condition of the battery
charge and battery temperature, the battery voltage will
increase at different rates as the battery charges.
Electrical System
o o o o
to 100 F (16 to 38
Page 5 - - 6
Voltage Measured
12.68 volts
12.45 volts
12.24 volts
12.06 volts
11.89 volts
Start the engine and run at high idle (3600 RPM). Allow
the battery to charge for at least 3 minutes. Record the
battery voltage.
After running the engine for at least 3 minutes, battery
voltage should be at least 0.50 volt higher than initial bat-
tery voltage.
An example of a charging system that is functioning:
At least 0.50 volt over initial battery voltage.
Initial Battery Voltage
Battery Voltage after 3 Minute Charge
Difference
Battery Charge Level
Fully charged (100%)
75% charged
50% charged
25% charged
0% charged
= 12.30 v
= 12.85 v
= +0.55 v
ProCore Processor