Toro ProCore Processor Service Manual page 81

Wheel Removal (Fig. 2)
1. Have ProCore Processor attached to tow vehicle
and park machines on a level surface. Engage vehicle
parking brake, stop engine and remove key from the
ignition switch. Make sure that Processor engine is off.
Chock wheels to prevent movement of either machine.
2. Secure lift axle to frame with hitch pin and lynch pin
to prevent lift axle from shifting.
3. Loosen but do not remove five (5) lug nuts that se-
cure wheel to be removed.
4. Jack or hoist Processor from ground and support
machine with jack stands (see Operator's Manual and
Jacking Instructions in Chapter 1 -- Safety).
5. Remove lug nuts and pull wheel from Processor
wheel hub.
ProCore Processor
Wheel Installation (Fig. 2)
1. Position wheel to wheel hub on raised machine.
2. Secure wheel to ProCore Processor with five (5) lug
nuts.
Failure to maintain proper lug nut torque could
result in failure or loss of wheel and may result in
personal injury.
3. Lower machine to ground. Alternately torque lug
nuts from 70 to 90 ft- -lb (95 to 122 N- -m).
4. Remove lynch pin and hitch pin from lift axle before
using ProCore Processor.
Page 6 - - 5
WARNING
Chassis