Table of Contents
Advertisement
RX RECORDING/DIGITAL (logger audio recording or digital decode levels).
VU meter: this "stacked LED" display shows the audio level into the analog
to digital controller. Note, the display is active only if a sample rate
is selected.
microKEYER II shows one sliders for each input – Left for the Main RX and
Right for the Sub RX. Keep the sliders at about 80% and use the RX Main
and RX Sub pots on the front panel for adjustment. When correctly
adjusted, the input signal should never show RED.
Sampling: sets the sample rate used for the RX level displays.
Because of the of the way the Windows sound system handles
multiple access to the sound card, always turn off the level displays
(set Sampling: off) when they are not in use.
Rec/RX Mixer: this button opens the Windows Record (Input) Mixer for the
selected sound card.
GET ID: this button will retrieve the name and number of the sound card.
The name can be used to verify that the correct sound card has been
selected. The Wave In ID can be used to configure software that identifies
sound cards only by number.
microHAM © 2008 All rights reserved
30
Advertisement
Table of Contents
