Samsung SPE-100 User Manual page 31

Setting up Port Range Forward for several network encoders
When several network encoder connect to one Broadband router device, you should
forward the TCP 943 port of the router to the TCP 943 port of a connected network
encoder.

J
If you don't set properly the TCP 943 port of the router, you cannot get any video stream from
the web page of the network encoder.
TCP 943 port is a port for the Silverlight policy server of a network encoder.
When Network encoder1 and Network encoder2 are connected to a router :
User
Broadband router
Start End
943 943
3000 3000
3001 3001
4520 4520
4521 4521
8080 8080
8081 8081
You can set a rule of Port Forwarding on the Broadband router device through its
confi guration web page.
You cannot change the Silverlight policy server port of a network encoder.
You can change the ports of the network encoder except the policy server port
through its confi guration web pages.
Internet
Protocol IP Address
TCP 192.168.1.100
TCP/UDP 192.168.1.100
TCP/UDP 192.168.1.101
TCP/UDP 192.168.1.100
TCP/UDP 192.168.1.101
TCP/UDP 192.168.1.100
TCP/UDP 192.168.1.101
Network Encoder1
(192.168.1.100)
Web Server Port 8080
VNP Port 4520
RTSP Port 3000
Policy Server Port 943
Network Encoder2
(192.168.1.101)
Web Server Port 8081
VNP Port 4521
RTSP Port 3001
Policy Server Port 943
English _31