Table of Contents
Advertisement
network connection and setup
6.
Click [OK].
Manual network setup will be completed.
If the Broadband router has more than one network encoder connected
Configure the IP related settings and the Port related settings distinctly with each other.
IP related settings
Port related settings
M
If the <HTTP Port> is set other than 80, you must provide the <Port> number in the address
bar of the Internet browser before you can access the network encoder.
ex) http://IP address : HTTP Port
http://192.168.1.100:8080
Auto Network Setup
Run <IP Installer_vX.XX.exe> to display the network encoder search list.
At the initial startup, both [Auto Set] and [Manual Set] will be grayed out.
M
Use the IP Installer in version 1.47 or later.
For network encoders found with the IPv6 setting, these buttons will be grayed out as the network
encoders do not support this function.
1.
Select a network encoder in the search
list.
Find the MAC (Ethernet) address labeled
on the rear of the network encoder.
Both the [Auto Set] and [Manual Set]
buttons will be activated.
2.
Click [Auto Set].
The Auto Setting dialog appears.
The <IP Address>, <Subnet Mask>, and <Gateway> will be set automatically.
28_ network connection and setup
Category
IP Address
Subnet Mask
Gateway
HTTP Port
VNP Port
Network encoder #1
192.168.1.100
255.255.255.0
192.168.1.1
8080
4520
Network encoder #2
192.168.1.101
255.255.255.0
192.168.1.1
8081
4521
Advertisement
Table of Contents
