Cub Cadet RZT-S Professional Shop Manual page 13

For Discount Cub Cadet Parts Call 606-678-9623 or 606-561-4983
Figure 2.5
Vent hose
Roll over valve
Figure 2.6
www.mymowerparts.com
1c.
1d. Unscrew the fuel cap.
Screw
NOTE: The fuel cap is tethered to the fender. This is an
EPA tier III requirement.
1e. Lift the fender off of the mower.
2. Clamp off the fuel line between the fuel tank and the
Fuel line
fuel filter. See Figure 2.6.
3. Disconnect the fuel line from the fuel tank at the fuel
filter.
4. Disconnect the fuel tank vent line from the roll over
valve.
5. Lift the fuel tank off of the mower.
6. Drain the fuel into an approved container.
7. Install the fuel tank by reversing previous steps.
8. Test drive the mower in a safe area before returning
it to service.
Engine Related Parts
Remove the screw from the front of the fender
using a T-27 torx driver. See Figure 2.5.
7