Table of Contents
Advertisement
■
P-TTL AUTO FLASH
Effective flash range
Refer to page 25 for the features and conditions of
use of this flash mode.
■ Procedure
1
Turn on the flash unit.
2
Press the flash mode button (MODE) until(P-
TTL) is displayed on the LCD panel.
26
3
Set the sync mode switch to leading curtain
sync (
), trailing curtain sync
(
), or contrast-control (
to the subject.
●After turning the power (ON), the setting will
be (P-TTL) and (A.Zoom).
4
Set the zoom position. (The setting method
differs according to your camera and lens.
Refer to page 23.)
5
Confirm that the subject is within the effective
flash range and the ready lamp is lit. Then
take a picture.
●The correct flash output is obtained in P-TTL
auto mode only when the flash unit is used
with autofocus lenses.
●If necessary, an exposure compensation
amount can be set between +1.0 to -3.0 steps
in 0.5-step increments.
), according
Advertisement
Table of Contents
