Table of Contents
Advertisement
Charging the flash with the
■
Optional External Power Source
Prepare the external power source TR Power
1
Pack-3 in accordance with the instruction in
the operating manual.
2
Confirm that the power switch of the flash unit
and TR Power Pack-3 is turned to OFF. Then,
plug the power cord into the external power
socket on the flash unit..
3
Turn the power switch of the external power
source and the power switch of the flash unit
to ON. When charging is complete the ready
lamp of the flash unit will light up.
When using the external power source, do
not remove the batteries from the flash:
otherwise, the flash unit will not function.
●The TR Power Pack-3 is equipped with a pilot
lamp which lights up to indicate that the
power is activated. Note that a lit lamp does
not indicate that the flash unit is ready for
use. Make sure the ready lamp on the flash
unit is lit before discharging the flash unit.
18
●When turning off the flash unit, make sure
you turn the power switch of the external
power source to OFF. Otherwise the external
power source may be exhausted.
Switching the Charging Mode
■
You can select a charging mode from among the
following.
PP1: Charge the flash unit using only the external
power source.
PP2: Charge the flash unit using the external
power source and internal batteries.
(The charging time will be shorter than PP1.)
1
Slide the setting switch up.
2
Press the LCD panel illumination button
(LIGHT) for 2 seconds or more. SL 1 or
SL 2 will be displayed.
3
Press the flash mode button (MODE) twice.
PP1 or PP2 will be displayed.
4
Press the select button (S) the number of
times required to select PP 1 or PP 2.
5
Press the LCD panel illumination button
(LIGHT). The LCD panel returns to the normal
display.
Advertisement
Table of Contents
