Table of Contents
Advertisement
SDM-090(P)
Digital Multiplexer
- The following screen is displayed if pressing the "ENTER" button when the blinking
position is at the "PASSWORD CHANGE...":
[PASSWORD CHANGE]
PASSWORD CHECK
- - - - - - - -
NEW PASSWORD
- - - - - - - -
CONFIRM
- - - - - - - -
¥ The password in shipment from factory is "12345678".
¥ The first digit from the initial password check blinks.
Press the current password in order of "1" ~ "9" of the "camera select" button.
¥ The first digit of the new password blinks if properly entering the password check as
per the current password.
¥ Enter 8 characters of the new password to set using the "1" ~ "9" of the "camera select"
button.
¥ Enter a new password once again from the CONFIRM.
¥ Message of "ERROR TRY AGAIN" is displayed on the bottom of screen if a password
entry error occurs and changed the password again in the above method. Turning it by
more than 3 times will completely escape from the setup menu.
¥ The changed setting value is stored if pressing the "SET" button and you can return to
the main menu.
"X" is displayed on screen when entering password.
5-11
Advertisement
Table of Contents
