Hdd Setting; Boot Up Delay - Mitsubishi Electric DX-TL2500E Installation And Operation Manual

HDD SETTING

The HDD SETTING can be set to MIRRORING (simulta-
neous recording to the internal HDD and peripheral record-
ing device HDD as a pair), PARTITION (an independent
partition that can be set within the total HDD memory spe-
cifically for ALARM RECORDING) and LONG PRE-ALARM
(Long-term pre-alarm recording is possible for maximum
30 minutes). (
TITION", "LONG PRE-ALARM")
<INITIALIZATION>
ID4•ID5
>>HDD SETTING

BOOT UP DELAY

POWER OFF
INITIALIZATION
ALL DATA WILL BE ERASED
WHEN PROCEED INITIALIZATION
BOOT UP DELAY
It is necessary to have connected peripheral recording de-
vices running before turning on the unit because the unit de-
tects peripheral recording devices when the POWER button
on the front of the unit is turned on. The detection time of pe-
ripheral recording devices by the unit can be delayed before-
hand for devices which take a long time to start-up.
Setting of "BOOT UP DELAY" ( default : "30S" )
"10S", "11S", • • • • • , "30S", • • • • • , "58S", "59S"
Set "BOOT UP DELAY" with enough time to ac-
commodate the start-up of peripheral recording devices.
When timer recording is set in the <TIMER PRO-
GRAMS SETTINGS> screen, setting the "BOOT UP
DELAY " with 30 seconds or more, the amount of time
to exceed 30 seconds in the set-up time of "BOOT UP
DELAY" is behind, and the record is started.
1. Turn ON the MAIN switch on the rear of the unit, and wait
until the ACCESS indicator goes off. Hold down the REC/STOP
button, and press the POWER button on the front of the unit.
• The <INITIALIZATION> screen is appears.
• The POWER button will not respond while the ACCESS
indicator is flashing.
2. On the <INITIALIZATION> screen, select "BOOT UP
DELAY" by turning the JOG dial, and turn the SHUTTLE ring
clockwise.
• The background of the "30S" turns red and flashes.
3. Display the desired time by turning the JOG dial, and turn
the SHUTTLE ring clockwise.
• The time is set, and the display stops flashing.
4. Select "POWER OFF" by turning the JOG dial, and turn the
SHUTTLE ring clockwise.
• The unit turns off.
5. Press the POWER button on the front of the unit again.
• After the set BOOT UP DELAY transpires, the unit starts
detection of peripheral recording devices.
• Confirm that the peripheral recording devices have been
detected correctly.
When exit the setting of "BOOT UP DELAY" select
the "POWER OFF" so that the data is not erased.
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• Initial settings
see pages 78-80 "MIRRORING", "PAR-
ARCHIVE•COPY
NORMAL
30S
19