Major Operations And Their Functions - Mitsubishi Electric DX-TL2500E Installation And Operation Manual

Major operations and their functions (continued)
Rear View (continued)
1
ON
MAIN
OFF
~
AC IN
7
REC terminal
Input terminal to start recording. Not available dur-
ing timer recording.
EMERGENCY terminal
Input terminal initiating immediate shift to EMER-
GENCY recording mode compulsorily.
MODE OUT 1 ~ MODE OUT 5 terminals
Output terminal to indicate the unit's current mode.
Select the unit's condition by MODE OUT 1 ~ MODE
OUT 5 setting in the <REAR TERMINAL SETTINGS>
menu.
CALL OUT terminal / CALL OUT GND terminals
This is the ISOLATION output terminal. Information
that can be transmitted externally consists of CALL
OUT settings made on the <REAR TERMINAL SET-
TINGS> menu screen as well as fixed output set-
tings.
DC 5V OUT terminal
Will only output when both the MAIN switch and
POWER button are ON. The maximum electric cur-
rent is 30mA.
14. RS-232C connector
This connector is used to connect to host device with
RS-232C connector. This unit can be controlled by
another device through this connector.
15. ETHERNET connector
Use a 10BASE-T cable to connect to the Ethernet
terminal. Please use the cable adapted to 10BASE-
T. DUPLEX MODE is HALF DUPLEX.
RECEIVE indicator
Illuminates when the unit is receiving a signal.
SEND indicator
Illuminates when the unit is transmitting a signal.
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
14
2 3
IN
1 2 3 4 5
OUT
OUTPUT A OUTPUT B
VIDEO Y/C
REMOTE
RESET
RS-485/
RS-422
8 9 10 11
4
CAMERA
6 7 8 9 10 11
GND
ALARM IN
RS-232C
12 13 14
16. SCSI connector
This connector is used to connect to peripheral re-
cording device.
6
5
IN
12 13 14 15 16
OUT
AUDIO MIC
OUT IN
ETHERNET
SCSI
RECEIVE SEND
15 16