Squaring.vise.to.blade - Grizzly G9742 Owner's Manual

Shipping Strap &
Stop Adjustment
To. ensure. that. your. bandsaw. arrives. without.
damage. to. the. hinge. system,. a. shipping. strap.
was.installed.. After. removing.the.shipping.strap,.
you. will. have. to. make. a. series. of. adjustments,.
beginning.with.the.feed.stop.bolt..
To remove the shipping strap and adjust the
feed stop bolt:
1.. Remove. the. shipping. strap. hex. bolt. and.
strap.with.a.12mm.wrench.(see.figure 11).
.
Note:.Keep this shipping strap in the event that
.
you must transport or ship the bandsaw.
2.. Adjust.the.feed.stop.bolt.and.jam.nut.with.a.
14mm.wrench.(figure 12),.so.the.bandsaw.
blade. teeth. are. just. below. the. table. surface.
when.the.cut.is.complete.
figure 11. Removing.shipping.strap.
figure 12. Feed.stop.bolt.
G9742 Metal Cutting Bandsaw (Mfg. Since 11/06
Squaring Vise to
Blade
To.ensure.that.your.bandsaw.will.make.cuts.that.
match.the.degree.scale,.you.must.make.sure.to.
square.the.vise.to.the.blade..
To square the vise to the blade:
1.. Rotate.the.headstock.until.the.pointer.reads.
"0". on. the. tabletop. scale,. and. tighten. the.
headstock.lock.lever.so.the.headstock.stays.
indexed.at.zero.
2.. Using. a. 6mm. wrench,. loosen. the. two. cap.
screws. that. hold. the. vise. to. the. table. (see.
figure 13).
Square
figure 13..Squaring.vise.to.blade,.headstock,.
and.table.scale.
3.. Using. a. small. machinists. square,. adjust. the.
vise.so.it.is.square.to.the.blade.
4.. Tighten.the.two.cap.screws,.so.the.vise.and.
blade.are.square.with.one.another.
Headstock.
Lock.Lever
-15-