Hitachi XP P9500 User Manual page 462

Message
ID
KAPL05040
-E
KAPL05041
-E
8-38
Message Text
path is correctly connected to the
disk.
The disk geometry or partition
information could not be set. IOCTL
= aa...aa, ErrorCode = bb...bb,
PathID = cc...cc After fixing the
path, change its status to Online.
Refer to the HDLM User's Guide for
instructions how to change the path
status to Online.
The contents of the configuration
definition file (dlmfdrv.conf) are
invalid. (Instance = aa...aa) Execute
the dlmsetconf command, and then
reboot. (bb...bb:cc...cc:dd...dd)
Messages
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
Explanation
aa...aa: Error code (decimal
number)
bb...bb: IOCTL code
(hexadecimal number)
cc...cc: Minor number of the sd
or ssd driver (hexadecimal
number)
Action
Check whether the path is
correctly connected to the disk.
Details
The HDLM filter driver sent a
request to the lower sd or ssd
driver for IOCTL for the disk
geometry or the partition
information settings, but an
error was returned.
aa...aa: IOCTL code
(hexadecimal number)
bb...bb: Error code (decimal
number)
cc...cc: Path ID (decimal
number)
Action
Remove the error from the
paths, and then place the paths
in the Online status. If the error
occurred for all of the paths,
retry the operation.
Details
A definition in the configuration
definition file for the HDLM filter
driver is invalid.
aa...aa:HDLM filter driver
instance number
bb...bb: Code indicating the
error type
cc...cc: Error information 1
dd...dd: Error information 2
Action
a Make sure the path is
.
connected to the disk
correctly.
b Execute the dlmsetconf
.
utility for creating the HDLM
driver configuration
definition file, and then
reboot.