Hitachi XP P9500 User Manual page 280

7 If you do not want HDLM to manage one of the LUs newly recognized by
.
the node, set up the LU so that it is excluded from HDLM management.
For details, see
Performing a New Installation of HDLM on page
to specify settings to exclude the LUs from HDLM management, skip to
step 8.
8 Execute the dlmcfgmgr utility shown below so that the HDLM driver
.
recognizes the LUs newly recognized by the node:
# /opt/DynamicLinkManager/bin/dlmcfgmgr -a
9 Make sure that the HDLM device of the LU recognized for the first time by
.
the HDLM driver is displayed by the format command.
Also check that the sd or ssd devices managed by HDLM are not displayed
by the format command.
command on page 4-34
command. The shaded portion indicates the HDLM device of the LU
recognized for the first time by the HDLM driver.
10 Check the status of the path accessing the LU recognized for the first time
.
by the HDLM driver.
The following shows an example of executing the command. The shaded
portion indicates the path accessing the LU recognized for the first time
by the HDLM driver.
4-34
Using the HDLM Device Unconfiguration Function When
Figure 4-4 Example of executing the format command
HDLM Operation
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
Figure 4-4 Example of executing the format
shows the example of executing the format
3-66. If you do not want