Hitachi XP P9500 User Manual page 301

Specify settings as shown in
Basis on page 3-142
page 3-146 of Removing Devices from VxVM on page
12 Stop all nodes in the cluster.
.
If the key is displayed in step 4, and the node is running in non-cluster
mode in step 6, execute the following command on all nodes:
# shutdown -g0 -y -i0
When running nodes in cluster mode, execute the following command on
any node:
# scshutdown -g0 -y
13 Start all nodes in the cluster simultaneously, in cluster mode.
.
At the ok prompt, execute the boot -r command.
Note
The following message might be output to the console window or
syslog while the node is running:
Could not read symbolic link for: /dev/rdsk/
c3t50060E80033A9902d2s2 path not loaded
This message is output when HDLM deletes a logical device file for an
sd or ssd device managed by HDLM. Perform the procedure for
updating the device ID information (steps 17 to 20) so that this
message is not output next time the node starts. For details, refer to
the Sun Cluster documentation.
14 Execute the dlnkmgr command's view operation on all nodes in the
.
cluster, and display the status of each program.
The following shows an example of executing the command:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys
HDLM Version
Service Pack Version
Load Balance
Support Cluster
Elog Level
Elog File Size (KB)
Number Of Elog Files
Trace Level
Trace File Size(KB)
Number Of Trace Files
Path Health Checking
Auto Failback
Intermittent Error Monitor
HDLM Manager Ver
Alive x.x.x-xx
HDLM Alert Driver Ver
Alive
HDLM Driver Ver
Alive x.x.x-xx
License Type Expiration
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
Removing Devices from VxVM on a Controller
or Removing Devices From VxVM on a Path Basis on
: x.x.x-xx
:
: on(extended lio)
:
: 3
: 9900
: 2
: 0
: 1000
: 4
: on(30)
: on(1)
: off
WakeupTime
yyyy/mm/dd hh:mm:ss
WakeupTime
x.x.x-xx yyyy/mm/dd hh:mm:ss 4096
WakeupTime
yyyy/mm/dd hh:mm:ss
HDLM Operation
3-140.
ElogMem Size
4-55