NEC NEAX 2000 IVS Installation Manual page 16

• Routed to a recorded announcement that can be administered by the CPE user
• Routed to a dial prompt
(b) This equipment returns answer supervision on all DID calls forwarded to the PSTN. Permissible ex-
ceptions are:
• A call is unanswered
• A busy tone is received
• A reorder tone is received.
EQUAL ACCESS REQUIREMENTS
This equipment is capable of providing users access to interstate providers of operator services through the use
of access codes. Modification of this equipment by call aggregators to block access dialing codes is a violation
of the Telephone Operator Consumers Act of 1990.
5. Regulatory Information on Single-Line Analog Telephones
NEC single-line telephones comply with Part 68 of FCC Rules. On the bottom of the equipment is a label that
states, among other information, the FCC registration number and ringer equivalence number (REN) for the
equipment. If requested, this information should be provided to the telephone company.
The equipment uses the following USOC jacks: RJ11C.
The equipment should be used only behind a PBX or KTS. The REN is used to determine the quantity of devices
that may be connected to the telephone line. Excessive RENs on the telephone line may result in the devices not
ringing in response to an incoming call. In most, but not all, areas, the sum of RENs should not exceed five (5.0).
To be certain of the number of devices that may be connected to the line as determined by the total RENs, contact
the telephone company to determine the maximum REN for the calling area.
6. Hearing Aid Compatibility
term
The D terminals provided for the NEAX2000 IVS are hearing aid compatible. FCC rules prohibit the use of
non-hearing aid compatible telephones.
NEC-type single-line telephone sets used in conjunction with the NEAX2000 IVS are hearing aid compatible.
If other than NEC-type single-line telephone sets are to be used with this system, ensure that these are hearing
aid compatible.
CAUTION: The act of monitoring or recording telephone conversations under certain circumstances may vi-
olate federal or state statutes. Consultation with your legal counsel prior to engaging in such prac-
tices would be advisable.
7. Industry Canada CS-03
Certification number: 140 5976A
Load Number of the equipment: 21
ND-45492 (E) REGULATORY INFORMATION
Revision 2.0
Page xi