Maintenance And Adjustment - Samsung SRP-350PG - SRP 350 B/W Direct Thermal Printer Service Manual

5 Maintenance and Adjustments 5 Maintenance and Adjustments 5 Maintenance and Adjustments 5 Maintenance and Adjustments
5-1 Adjustment 5-1 Adjustment 5-1 Adjustment 5-1 Adjustment
5-1-1 Remaining Roll Paper Adjustment 5-1-1 Remaining Roll Paper Adjustment 5-1-1 Remaining Roll Paper Adjustment 5-1-1 Remaining Roll Paper Adjustment
This sensor is set to the step3 position at the factory. If you find that there is not or too enough paper remaining
on the roll when the near-end sensor is triggered, you can change the setting to the upper or Lower position
as described below.
Note : The factory setting is based on a paper r o ll core with an outside diameter of 18mm. If you use a paper roll Note : The factory setting is based on a paper r o ll core with an outside diameter of 18mm. If you use a paper roll Note : The factory setting is based on a paper r o ll core with an outside diameter of 18mm. If you use a paper roll Note : The factory setting is based on a paper r o ll core with an outside diameter of 18mm. If you use a paper roll
with a cor e with an outside diameter of mor e than 18mm, it is better to change to the upper position with a cor e with an outside diameter of mor e than 18mm, it is better to change to the upper position with a cor e with an outside diameter of mor e than 18mm, it is better to change to the upper position with a cor e with an outside diameter of mor e than 18mm, it is better to change to the upper position
(Rotate the tab at front side) as described below. (Rotate the tab at front side) as described below. (Rotate the tab at front side) as described below.
1. Open the paper roll cover.
2. Rotate the tab at front or rear Position.
Note : For your r eference, this shows the diameter at which the near - end sensor is triggered. Note that this figur e
is a calculated value, and there may be some variations depending on the printer.
Samsung Electro-Mechanics
Near end sensor tab
Figure 5-1 Adjusting the Paper Near End Sensor Figure 5-1 Adjusting the Paper Near End Sensor Figure 5-1 Adjusting the Paper Near End Sensor Figure 5-1 Adjusting the Paper Near End Sensor
Figure 5-2 Paper Remaining Amount for Paper Spool Diameter Figure 5-2 Paper Remaining Amount for Paper Spool Diameter Figure 5-2 Paper Remaining Amount for Paper Spool Diameter Figure 5-2 Paper Remaining Amount for Paper Spool Diameter
5-1 5-1 5-1 5-1