Samsung SRP-350PG - SRP 350 B/W Direct Thermal Printer Service Manual page 42

4 Disassembly and Assembly
4-3 Frame Block
Screw (3x8)
11
Cover Sensor PCB
12
Guide Button
10
Screw (3x8)
6
Figure 4-14 Disassembly Frame #5
2
4 Brkt-Hook
Figure 4-15 Disassembly Frame #6
4-8
Frame Main
3
Plate-Spring
13
Screw (3x8)
14
Lever Release
5
Control Board
2
Screw (3x8)
1
Washer
4
Slip
Spring
9
Release
Button Assy
7
Push Button
8
1 Spring Hook
3 Screw (3x4.4)
1. Remove the screw 1 . And separate the
Control-Board 2 from the Frame-Main 3 .
2. Remove the washer slip 4 .
3. Separate the Lever-Release 5 from the
Frame-Main 3 .
4. Remove the two screw 6 .
5. Separate the Button Assembly 7 from the
Frame-Main 3 .
6. Push the Button 8 . Then, the Button
Assembly is separated (Internal Spring
Release 9 , Guid-Button 10 ).
7. Remove the screw 11 . And separate the
Cover-Sense PCB 12 from the Frame-
Main 3 .
8. Remove the screw 14 . And separate the Plate-
Spring 13 from the Frame-Main 3 .
1. Remove the screw 4 in the Frame-Main 1 (3PCS).
2. Separate the Knob paper End 2 .
3. Separate the Housing paper End 3 (2PCS).
4. Separate the Sub-Board 5 (2PCS).
5. Remove the Washer slip 6 . And Separate the
Gear - Idle 7 from the Frame Main 1 .
6. Remove the two Screw 8 . And Separate the
Motor STEP 9 from the Frame -Main 1 .
Samsung Electro-Mechanics