Tacacs+ Commands; Tacacs-Server Host - HP BladeSystem bc2000 - Blade PC Reference Manual

tacacs-server host

The tacacs-server host Global Configuration mode command specifies a TACACS+ host. To
delete the specified name or address, use the no form of this command.
Syntax
tacacs-server host {ip-address | hostname} [single-connection] [port port-number] [
timeout] [key key-string] [source source] [priority priority]
no tacacs-server host {ip-address | hostname}
Parameters
ip-address — IP address of the TACACS+ server.
n
hostname — Host name of the TACACS+ server. (Range: 1-158 characters)
n
single-connection — Indicates a single-connection. Rather than have the device open and
n
close a TCP connection to the daemon each time it must communicate, the single-connection
option maintains a single open connection between the device and the daemon.
port-number — Specifies a server port number. (Range: 0-65535)
n
timeout — Specifies the timeout value in seconds. (Range: 1-30)
n
key-string — Specifies the authentication and encryption key for all TACACS+
n
communications between the device and the TACACS+ server. This key must match the
encryption used on the TACACS+ daemon. To specify an empty string, enter "".
(Range: 0-128 characters)
source — Specifies the source IP address to use for the communication. 0.0.0.0 indicates a
n
request to use the IP address of the outgoing IP interface.
priority — Determines the order in which the TACACS+ servers are used, where 0 is the
n
highest priority. (Range: 0-65535)
Default Setting
No TACACS+ host is specified.
If no port number is specified, default port number 49 is used.
If no host-specific timeout, key-string or source value is specified, the global value is used.
If no TACACS+ server priority is specified, default priority 0 is used.
Command Mode
Global Configuration mode
CLI Reference Guide

TACACS+ Commands

www.hp.com
26
timeout
26-1