Policy-Map - HP BladeSystem bc2000 - Blade PC Reference Manual

policy-map

The policy-map Global Configuration mode command creates a policy map and enters the
Policy-map Configuration mode. To delete a policy map, use the no form of this command.
Syntax
policy-map policy-map-name
no policy-map policy-map-name
Parameters
policy-map-name — Specifies the name of the policy map.
n
Default Setting
If the packet is an IP packet, the DCSP value of the policy map is 0.
If the packet is tagged, the CoS value is 0.
Command Mode
Global Configuration mode
Command Usage
Before configuring policies for classes whose match criteria are defined in a class map, use the
policy-map Global Configuration mode command to specify the name of the policy map to be
created or modified.
Class policies in a policy map can only be defined if match criteria has already been defined for
the classes. Use the class-map Global Configuration and match Class-map Configuration
commands to define the match criteria of a class.
Only one policy map per interface per direction is supported. A policy map can be applied to
multiple interfaces and directions.
Example
The following command creates a policy map called policy1 and enters the Policy-map
Configuration mode.
Console (config)# policy-map policy1
Console (config-pmap)#
HP PC Blade Switch CLI Reference Guide www.hp.com
QoS Commands
18-7