Negotiation - HP BladeSystem bc2000 - Blade PC Reference Manual
Command line interface reference guide hp bladesystem pc blade switch
Hide thumbs
Also See for BladeSystem bc2000 - Blade PC:
- User manual (216 pages) ,
- Administrator's manual (104 pages) ,
- Setup and installation manual (104 pages)
Table of Contents
Advertisement
negotiation
The negotiation Interface Configuration (Ethernet, port-channel) mode command enables
auto-negotiation operation for the speed and duplex parameters of a given interface. To disable
auto-negotiation, use the no form of this command.
Syntax
negotiation [capability1 [capability2...capability5]]
no negotiation
Parameters
capability — Specifies the capabilities to advertise. (Possible values: 10h, 10f, 100h,100f,
n
1000f)
Default Setting
Auto-negotiation is enabled.
If unspecified, the default setting is to enable all capabilities of the port.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
Command Usage
If capabilities were specified when auto-negotiation was previously entered, not specifying
capabilities when currently entering auto-negotiation overrides the previous configuration and
enables all capabilities.
Example
The following command enables auto-negotiation on Ethernet port e42.
Console(config)# interface ethernet e42
Console(config-if)# negotiation
HP PC Blade Switch CLI Reference Guide
www.hp.com
Ethernet Configuration Commands
8-7
Advertisement
Table of Contents
