Table of Contents
Advertisement
11. Connect the signal cable and the power cable to the new hard disk drive. See
Replacing the front fan assembly
Depending on the model type, your server might have a front fan assembly
installed. This section provides instructions on how to replace the front fan
assembly.
To replace the front fan assembly, do the following:
1. Remove all media from the drives and turn off all attached devices and the
2. Remove the server cover. See "Removing the server cover" on page 18.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on
4. Disconnect the front fan assembly cable from the power fan connector on the
40
Installation and User Guide
"Connecting a SATA drive" on page 27.
What to do next:
v To work with another piece of hardware, go to the appropriate section.
v To complete the replacement, go to "Completing the parts replacement" on
page 44.
Attention
Do not open your server or attempt any repair before reading and
understanding the "Safety" on page v and the Safety Information book. To
obtain a copy of the Safety Information book, go to:
http://www.lenovo.com/support
server. Then, disconnect all power cords from electrical outlets and disconnect
all cables that are connected to the server.
page 19.
system board. See "System-board internal connectors" on page 14.
Note: If your server has a secondary hard disk drive installed, remove the
secondary hard disk drive to get easier access to the power fan connector on
the system board. See "Installing or replacing the secondary hard disk drive"
on page 28.
Advertisement
Table of Contents
