Lenovo 098118U Installation And User Manual page 40

User manual
Hide thumbs Also See for 098118U:
Table of Contents

Advertisement

To install or replace a memory module, do the following:
1. Remove all media from the drives and turn off all attached devices and the
2. Remove the server cover. See "Removing the server cover" on page 18.
3. Lay the server on its side for easier access to the system board.
4. Locate the memory slots. See "System-board internal connectors" on page 14.
5. Remove any parts that might prevent your access to the memory slots.
6. If you are installing a new memory module, open the retaining clips of the
Figure 11. Opening the retaining clips
Figure 12. Removing a memory module
24
Installation and User Guide
server. Then, disconnect all power cords from electrical outlets and disconnect
all cables that are connected to the server.
Note: Depending on your server model, you might need to remove the PCI
Express x16 card for easier access to the memory slots. See "Installing or
replacing a PCI card" on page 20.
memory slot into which you want to install the new memory module.
If you are replacing an old memory module, open the retaining clips and
gently pull the memory module out of the memory slot.

Advertisement

Table of Contents
loading

Table of Contents