Replacing The Rear Fan Assembly - Lenovo 10HJ User Manual

6. Slide the new hard disk drive into the hard disk drive bay and align the screw holes in the new hard
disk drive with the corresponding holes in the drive bay. Then, install the four screws to secure the
new hard disk drive in place.
Figure 30. Installing the hard disk drive
7. Connect one end of the signal cable to the rear of the new hard disk drive and the other end to an
available SATA connector on the system board. See "Locating parts on the system board" on page 12.
Then, locate an available four-wire power connector and connect it to the rear of the new hard disk drive.
Figure 31. Connecting a SATA hard disk drive
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 73.

Replacing the rear fan assembly

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
on page v.
.
Chapter 5 Installing or replacing hardware
59