Table of Contents
Advertisement
9. Press the hard disk drive cage downward until it snaps into position. Make
sure that the hard disk drive cage is secured in the chassis.
Figure 22. Installing the secondary hard disk drive
10. Continue at "Connecting a SATA drive" on page 27.
Replacing the secondary hard disk drive
Note: Depending on the model type, your server might have a secondary hard
disk drive installed.
To replace the secondary hard disk drive, do the following:
1. Remove all media from the drives and turn off all attached devices and the
server. Then, disconnect all power cords from electrical outlets and disconnect
all cables that are connected to the server.
2. Remove the server cover. See "Removing the server cover" on page 18.
3. Locate the secondary hard disk drive. See "Internal drives" on page 16.
4. Disconnect the signal cable and the power cable from the hard disk drive.
Chapter 5. Installing or replacing customer replaceable units
31
Advertisement
Table of Contents
