External Alarm Sensor Setup; Using As A Monitor Board During A Motion Sensor Alarm; Connecting A Remote Control Circuit - Sanyo MPX-CD163 Instruction Manual

CONNECTIONS

External alarm sensor setup

In order to make an external alarm sensor operate, an external
switch must be connected to an ALARM IN connector. When an
intruder activates the external switch (such as by opening a
door), an alarm signal is received and an alarm can be made to
sound.
The MPX-CD93 model uses the connectors marked *.
Connect an external switch
to an ALARM IN connector
*
*
*
*
*
*
*
*
*
SENSOR ALARM OUT connector

Connecting a remote control circuit

If a remote control circuit is constructed as shown in the illustration and connected to the remote control input (R1 and R2) terminals of
the CONTROL connector, the multiplexer can be operated by remote control. (Contact LOW input)
The MPX-CD93 model can control up to nine cameras.
Note:
SW: Switch
The remote control cable should
be no more than 5 m long.
Using as a monitor board during a
motion sensor alarm
When the motion sensor built into the multiplexer responds to an
alarm, it outputs an alarm signal to the SENSOR ALARM OUT
connector. If a switching circuit such as a warning lamp is
connected to this connector, the warning lamp will illuminate
when there is a response from the motion sensor. If the warning
lamp is fixed somewhere in the layout diagram for an area such
as a factory, the location of the camera can be ascertained in an
instant during an emergency. The connector is always open.
The pin corresponding to the number of the camera that
generates a sensor response switches to Low.
1K
R1 R2
220 220
SW 17: Menu selection
SW 1: Camera1
220 220
SW 2: Camera2 SW 18: Video playback
300 300
SW 3: Camera3 SW 19: Live image
360
360
SW 4: Camera4 SW 20: Multi display
470 470
SW 21: Plus display
SW 5: Camera5
680 680
SW 6: Camera6 SW 22: Auto camera switching
820 820
SW 7: Camera7 SW 23: Electronic zoom
1.2k
1.2k
SW 8: Camera8 SW 24: Still image
1.8k 1.8k
SW 25: Spot monitor
SW 9 : Camera9
2.2k 2.2k
SW 10 : Camera10 SW 26: 4-screen display
3.3k 3.3k
SW 11 : Camera11 SW 27: Next
4.7k
4.7k
SW 12 : Camera12 SW 28: Previous
7.5k 7.5k
SW 29: +
SW 13 : Camera13
13k 13k
SW 14 : Camera14 SW 30: –
27k 27k
SW 15 : Camera15 SW 31:
68k
68k
SW 16 : Camera16 SW 32:
– 12 –
Rated values for each connector (at 25˚C)
• Max. current 25mA
• Max. voltage 25V
• Max. power 40mW
3
2
English