Yamaha RX-V750 Owner's Manual page 78

IW_le]ilhV[eff_e]lhVplT, l_llel'J__f:L_li_l_l_l_.f "
4
Press A / v to select
the parameters.
Press < / > to change
the parameter value.
When you set a parameter
to a value other than the
factory-set value, an
asterisk mark (*) appears
by the parameter name on
the front panel display.
Repeat steps 3 through 5 as necessary to
change other program parameters.
You cannot change parameter values when "MEMORY GUARD"
is set to ON. If you want to change the parameter wdues, set
"MEMORY GUARD" to OFF (see page 60).
Memory back-up
The memory back-up circuit prevents the stored data
from being lost even if this unit is set in the standby
mode, the power cord is disconnected from the AC
outlet, or the power supply is temporarily cut clue to
power fidlure. However, if the power is cut tUr more
than one week, the parameter values will return to the
factory settings. If this happens, edit the parameter
value again.
• Resetting parameters to the factory
presets
To reset a certain parameter
Select the parameter you want to reset, then press <(/ )
repeatedly until the asterisk mark (*) next to the parameter
name disappears.
To reset all parameters
Use PARAM. IN] (see page 61).
74