Yamaha RX-V750 Owner's Manual page 71

;/:[l_[I]l:ll,[I]_lll:{I]J._.___|ll]:/:[,
• "NG" appears in the display window if programming was
/lllS[Iccessltll. In this case, start over fronl step 5.
• This remote control can learn approximately 120 fnnclions.
However depending on tile signals learned. "FULL" may
appear in Ihe display before you progranl 120 functions. In Ihis
case. clear unnecessary programmed lunctions to make room
for further learning.
6 Repeat steps 4 and 5 to program additional
functions.
7 Press LEARN again to exit from the learning
mode.
•_ iJ id L;i
• Learning may not be possible in the %llowing cases:
When the batteries in the remote control for this unit or other
components are weak.
When the distance between the two remote controls is too
great or too smalh
When the remote control infrared windows are not lacing at
the appropriate angle.
When the remote control is exposed to direct sunlight.
When the function to be programmed is continuous or
uncommon.
• "ERROR" appears in the display window if you press more than
one button at the same time.
Yon can change the name that appears in the display
window on the remote control if you want to use a
different name to the one that is set as the ti_ctory preset.
This is useftd when yon have set the input selector to
control a different component.
Press an input selector button to select the
source component you want to rename.
The selected component name appears in the display
window.
i._ ¸ _ _ _i
2
Press RE-NAME using a
ballpoint pen or similar
object.
Press/,, / v to select and enter a character.
Pressing v changes the character as follows:
A to Z, a to z, 0 to 9, space, -(hyphen), and/(slash).
(Pressing/_ changes the characters in reverse order.)
i;i f !J!i
4
Press < / > to move the cursor to the next
position.
If you want to continue setting up names for other
components, press TV MUTE/SELECT and repeat steps I,
3 and 4.
Press RE-NAME again to exit from the
renaming mode.
67