Yamaha RX-V750 Owner's Manual page 31

lql'lFl-"ilq
For best results, make sure the room is as quiet as possible
during the auto setup procedure (YPAO). If there is too
much ambient noise, the results may not be satisfactory.
If your subwooli:r has at[iustablevolume and crossover/high cut
frequency controls, set the volume belween 9 and 11 o'clock (as
viewed oil a conventional clockface) and set the crossover/high
cut frequency to the nmximmn.
VOLUME
©
MI_ MAX
Subwoofer
OROSSOVER'
HIGH CUT
Switch on this unit and your video monitor.
Make sure the OSD is displayed.
Press AMP.
Press SET MENU.
4
Press/,, / v to select AUTO SETUP.
A
++"
+++_] r+3LP+Itl
..... ii_i% +
÷ +MI+JTCI I_;ETLIF'
+P'IMI4I.fI_L _+,t,'-E'r"m,
[1] [T];LIs: [:,o/,ir_
5 Press SELECT to enter AUTO SETUP.
Press/,, / v to select SETUP, then press < / >
to select the desired setting.
+==H%== ++_V+IH
SETUP, ...... F,LITO
Nutonatic
c4 _,IIite+,_:_
[1] _[T] UF [)o/F/
[<] [ }] _s,_=l,_,ct
,...,,...+......., +..., To perfonn the auto setup procedure
(YPAO).
.............. "+ To reload the last auto setup (YPAO)
1... k. i.. ,.., r...q..= <
settings to override any manual
changes.
+...,,+ ii..+r'.,+",_,....+..., To undo the last auto setup (YPAO) and
restore the previous settings.
,....,...,r"i::r+::v"i,...,,...+,...+i T, To restore the factory preset (default)
setup parameters.
You can choose RELOAD or UNDO only if you have
already performed auto setup.
Press v to select START, then press SELECT
to start the setup procedure.
• If you selected AUTO in step 6, kind test tones "a.ill
be output from each speaker in turn; WAIT appears
during the auto setup procedure.
• If you selected DEFAULT, RELOAD or UNDO in
step 6, no test tones are output.
+==H%== _+_VLIII
5ETLIF q ...... F,Ur 0
-+ 5TMR]
Aut o+,_tic
r_r o c e:_ :+i rl,;._
c,, _ _AI ite+_:_
[SELECT ] ;E;t _r t
The RESULT:WIRING screen appears after all items
have been measured and set.
M,M,2+O +, +,,'0_,0,,_
FROTH i_+ ......
++1}
[i ]• [ ) ]: Se 1ect
[SELEC:'T] Fqe[+.4_ r_
• If an ERROR screen appears, see "If an error
screen appears" on page 28.
• If a WARNING screen appears, see "If a warning
screen appears" on page 29.
27