Yamaha RX-V750 Owner's Manual page 70

|:/:[j_[o]l:ll,[oATil:{o]Jffff__|ll]:/._
If you want to program functions not included in the basic
operations covered by the manufacturer code, or an
appropriate manufacturer code is not available, do the
following. You can program any of the buttons available in
the component control area (see page 62). The buttons can
be programmed independently for each component.
This rmnote control transnlits infrared rays. If the other remote
control also uses infrared rays. this remote control can learn most
of its limctions. However. you may not be able to program sonm
special signals or extrenmly long transmissions. (Refer to the
operating instructions for the remote control of your component.)
1 Press an input selector button to select a
source component.
Place this remote control about 5 to 10 cm
apart from the other remote control on a flat
surface so that their infrared transmitters are
aimed at each other.
@
DD@[]
[] [][][]
[] [][][]
[] _[][]
5to tO cm (2 to 4 in)
Press LEARN using a ballpoint pen or similar
object.
Do not press and hold LEARN. If you hold it down
for more than three seconds, the remote enters the
manufacturer code setting mode.
i i',_ IJ N i_
-
l
l!i F_
Flashes alternately
Complete each of the lollowing steps in 31)seconds.
Otherwise. the learning mode will be automatically
canceled. In this case. press LEARN again.
Press the button at which you want to
program the new function.
"LEARN" is displayed.
O!Oi @ E]_
O_O Oi Oi oi
00@0! ol o_
DDD
[]
Fs FSD•
DE}DE}
_ __8
Press and hold the button you want to
program on the other remote control until
"OK" appears in the display window.
7]i/i1/
[XXi
i/ iXXl iNK/ (3
iiiiiiiii!Uiii 0 J_! !JJJJiii!i iiii!!iiii!!
66