Patching Direct Outs - Yamaha 02R96 Owner's Manual

70
Chapter 6—Input & Output Patching

Patching Direct Outs

Direct Outs can be patched to the Slot Outputs, Omni Outs, or 2TR Digital Outputs.
The Direct Out Destination parameters for the 56 Input Channels are divided between two
pages. The Input Channel 1–48 Direct Out Destination page is shown below. The layout of
the other page is the same.
In addition to using the cursor buttons, Patch parameters can also be selected by using the
LAYER and [SEL] buttons.
Patching the 2TR Digital Outputs
Bus Outs, Aux Sends, the Stereo Out, Input or Output Channel Insert Outs, or the Control
Room signal can be patched to the 2TR Digital Outputs. 2TR Digital Outputs can be
patched to Direct Outs on the Direct Out Destination pages (see page 70). The left and right
channels of each Digital Output can be patched individually.
When a 2TR Digital Output is patched to a Direct out (see page 70), and that Direct Out is
assigned on an Input Channel Routing page, the 2TR Digital Output patch cannot be
changed here.
02R96 Version 2—Owner's Manual