Midi Port Setup - Yamaha 02R96 Owner's Manual

MIDI Port Setup

MIDI ports are configured as follows.
Use the DISPLAY ACCESS [SETUP] button to locate the MIDI/TO HOST Setup
1
page.
Use the cursor buttons to select the parameters, and use the Parameter
2
wheel, INC/DEC buttons, and [ENTER] button to set them.
TO HOST SERIAL: These buttons are used to configure the TO HOST SERIAL port for
use with either a Mac or PC.
Caution: When a PC is connected to the TO HOST SERIAL port, do not set this to Mac
because your PC may crash.
GENERAL: These parameters are used to select ports for general MIDI data transmission
and reception, including Program Changes for recalling Scenes, Control Changes for
real-time parameter control, and Note On/Off for use with the Freeze effect. Available ports
include: MIDI, SERIAL 1–8, USB 1–8, and SLOT1.
MIDI THRU: These parameters allow you to route the incoming MIDI data from one port
through to another port. Available ports include: MIDI, SERIAL 1–8, USB 1–8, and SLOT1.
REMOTE1: This parameter is used to select a port for the Remote Layer. Available ports
include: MIDI, SERIAL 1–8, USB 1–8, and SLOT1. If Pro Tools is selected as the target for a
Remote Layer, "Pro Tools" is displayed here and no settings can be made.
Studio Manager: These parameters are used to select a port for use with the Studio
Manager software and to assign the 02R96 an ID from 1 to 8. Available ports include: MIDI,
SERIAL 1–8, USB 1–8, and SLOT1. See the Studio Manager documentation for more infor-
mation.
DAW: These parameters are used to select ports for use with DAWs. Since four ports are
required to control DAWs, ports are selected in groups of four, as follows: 1–4, 2–5, 3–6,
4–7, 5–8. Available ports include: SERIAL, USB, and SLOT1.
PLUG-IN1–4: These parameters are used to select ports for use with the Plug-Ins. If a
Waves Plug-In card is installed in a Slot, the number of that Slot is displayed and no settings
can be made. If the Plug-In target is set to USER DEFINED, you can select a port from
MIDI, SERIAL 1–8, USB 1–8, or SLOT1. Ports for User Defined Plug-Ins can also be set on
the Plug-In Setup page (see page 159).
Note: Some functions cannot share ports. If you try to assign a port that's already assigned to
such a function, the message "Change Port?" appears. If you select YES, the port will be assigned
to the selected function and the previously assigned function will be set to "NO ASSIGN."
191
MIDI Port Setup
02R96 Version 2—Owner's Manual